Works on Its Own
Each module is self-aware and needs no separate control device. It watches the frequency of the power being produced and sheds its load if frequency drops.
Generac G007000-0 50A Smart Management Module: automatically sheds a 240V load when generator frequency drops, with priority settings from 1 to 8 and a lock-out mode. NEMA 3R enclosure, for standby generators and PWRcell systems.
$238.00
Priced per project
Send us your details and we will prepare a quote for your site.
Get a Free Quote Or call 1-844-443-6776The G007000-0 lets a Generac generator or PWRcell system carry a large 240V appliance without being sized to run it all the time. If the generator gets close to its limit, the module disconnects that load so the system can recover, then reconnects it later.
Best fit: single 240V loads up to 50 A resistive or 40 A inductive, where managing the load allows a smaller generator or keeps a larger one out of trouble.
Each module is self-aware and needs no separate control device. It watches the frequency of the power being produced and sheds its load if frequency drops.
A dial sets priority from 1 to 8. Each managed load gets a unique priority so no two try to start at the same time.
A switch can keep a load off for the whole outage, for things that do not need to run on generator power.
Frequency reflects what the generator can actually deliver, so heat, elevation and fuel type are already accounted for.
An LED visible through an external window shows load connected, load shed, 30-minute lockout, generator load lockout or no power.
A UL 50 enclosure rated NEMA 3R, with a test button that disables the contactor output for a specified time.
This size suits loads such as an electric water heater or dryer, within the 50 A resistive rating, or a motor load within the 40 A inductive and 180 A locked rotor ratings. We check the nameplate of the actual appliance rather than going by its breaker alone.
One module controls one load. Each gets its own unique priority, and the most important load gets the highest priority so it is the last to be shed.
Generac recommends sizing the generator with enough excess capacity to start the largest managed load, since that load has to be able to start when its turn comes. Up to eight modules can be used in one system.
Generator Experts is the generator side of Platinum Electrical Contractors, a licensed Ontario electrical contractor working since 1991. We work out which loads to manage as part of generator installation, wire the modules, and set the priorities for your home. Modules can be added to an existing system too, and they work with the load management in most of our transfer switches.
Send us your panel photos and a list of your big appliances. We will show you what a managed system would need.
A member of our team will be in touch shortly to discuss how we can help to meet your needs.
Reviews
There are no reviews yet.